Начальная настройка Microtik Router OS

[mkt@MikroTik] > setup.

Setup uses Safe Mode. It means that all changes that are made during setup are.

reverted in case of error, or if.

Ctrl-C is used to abort setup. To keep changes exit setup using the `x' key.

[Safe Mode taken].

Choose options by pressing one of the letters in the left column, before dash.

Pressing `x' will exit current.

menu, pressing Enter key will select the entry that is marked by an `*'. You can.

abort setup at any time by.

pressing Ctrl-C.

Entries marked by `+' are already configured.

Entries marked by `-` cannot be used yet.

Entries marked by `X' cannot be used without installing additional packages.

r — reset all router configuration.

+ l — load interface driver.

+ a — configure ip address and gateway.

d — setup dhcp client.

* s — setup dhcp server.

p — setup pppoe client.

t — setup pptp client.

x — exit menu.

your choice [press Enter to setup dhcp server]:

+ a — add ip address.

+ g — setup default gateway.

* x — exit menu.

your choice: a.

enable interface: ether1.

ip address/netmask: 192.168.1.116/24.

#Enabling interface.

/interface enable ether1.

#Adding IP address.

/ip address add address=192.168.1.116/24 interface=ether1 comment="added by setup" .

+ a — add ip address.

+ g — setup default gateway.

* x — exit menu.

your choice: a.

enable interface: ether2.

ip address/netmask: 192.168.0.1/24.

#Enabling interface.

/interface enable ether2.

#Adding IP address.

/ip address add address=192.168.0.1/24 interface=ether2 comment="added by setup" .

your choice: g.

gateway: 192.168.1.249.

#Adding default route.

/ip route add dst-address=0.0.0.0/0 gateway=192.168.1.249 comment="added by setup" .